During defects appearing on our generator units, we usually proceed immediate repairing. But we always omit those “small problems” during repairing, which will lead many unnecessary problems left. We will explain some main mistakes during repairing generator units.
No. 1: we always make mistakes by omit “small” mistakes to suffer “big” losses; specifically, when we repairing generator units, we always focus on main and big components, such as fuel pump, oil tank or cylinder; however we always omit gasket, air filter, engine oil filter, water temperature meter, oil temperature meter, oil pressure meter, etc. but in fact, many defects oriented from these “small” problems. So we must consider complete situation of system, not only focus on big defects, but also settle small problems on time, then the whole generator system will be protected completely.
N. 2: incomplete dispose for rust components, which cause corrosion and early worn out. When we proceed repairing on generator units, we always repair defects only, seldom analyze the reason and prevent problems. So we must keep in mind that after repair or daily maintenance finished, all dirt or oil on the machine must be cleaned carefully, otherwise, they will become future problems.
No. 3: omitted repair taboo problems, to cause engine continuously failure. This mainly because of some technicians’ lack of correct acknowledgement, to cause generator units always failure. Wagna remind you, please always clean the generator and correct technician’s mistakes while maintaining and repairing generator units.